What do you do when a PCB is cracked or even broken in two? [MH987] has a plan: superglue the board back and then bridge the traces with solder, solder paste, or wire. The exact method, of course, … ...

A previous repair attempt left the PCB badly damaged. When presented with so many damaged traces on the PCB, the most reasonable course of action would have been to get a donor cartridge and swap ...

I'm wondering if I can take the cracked pcb and using wire and solder re-connect all the traces again. This amp is rated at 800watts, but I was only using it for my door and rear deck speakers so ...

He had to grind into the other side of the graphics card PCB to three layers deep to find a metallic trace at a precise point. To this point the GPU pad wire would be soldered to reconnect to the ...

Sketch your circuit "Trace the footprints of your components directly on to the paper [in pencil], then connect the dots between these footprints to draw in all the connections in the circuit." ...

On the same PCB trace, repair your first cut and then make a second measurement of driving-point impedance, this time cutting the circuit in the middle. Do you suppose that Z 2 differs from Z 1 ?